Evaluating slow sand filtration for bio-slurry post treatment: a step toward safe non-potable water reuse in rural communities in Uganda
Evaluating slow sand filtration for bio-slurry post treatment: a step toward safe non-potable water reuse in rural communities in Uganda
Date
2026
Authors
Tugumisirize, Genious
Journal Title
Journal ISSN
Volume Title
Publisher
Makerere University
Abstract
Small-scale biogas digesters in peri-urban Uganda generate large volumes of nutrient-rich but poorly managed bio-slurry, while also placing additional demand on already-scarce water resources. This study evaluated slow sand filtration (SSF) as a low-cost post treatment technology for bio-slurry generated from a household-scale cattle dung digester at the Joint Energy and Environment Projects (JEEP) Renewable Energy Demonstration Centre in Kyanja, Kampala, with the aim of enabling safe non-potable water reuse in rural and peri-urban communities. Raw bio-slurry from the digester was characterised for its physico-chemical and
microbiological properties, and a sieve analysis of the candidate filter sand was carried out to determine its particle size distribution and design parameters. Two laboratory-scale SSF prototypes, differing in sand effective size (D₁₀ = 0.45 mm sieved sand for Filter 1 and D₁₀ > 0.05 mm river sand for Filter 2), were designed, constructed, and operated for seven days at a hydraulic loading rate of 10 L/m²·h. Performance was assessed through effluent volume and filtration velocity measurements taken on Days 1, 3, and 7, and through a physico-chemical and microbiological analysis of the effluent at the end of the experimental period.
Raw slurry exhibited high organic loading (COD = 3,300 mg O2/L), high suspended solids (TSS = 150 mg/L), high turbidity (454.3 NTU), high electrical conductivity (16 mS/cm), and highly contaminated by microbes (Too Numerous To Count for both total coliforms and E. coli). After treatment, COD, TSS, total dissolved solids, total solids, turbidity, and electrical conductivity were reduced by 69.7%, 33.3%, 73.2%, 70.5%, 57.8%, and 50.0% respectively, hence satisfying the discharge limits set by Uganda NEMA for TSS, TDS, turbidity, and temperature. However, there was no observed reduction in the number of total coliforms and E. coli within the period of seven days, which means that the schmutzdecke bio-layer has not developed enough to remove pathogens. The sand media used had equal hydraulic properties since the filtration velocity converged in the third run, meaning that locally obtained river sand is equally effective as sieved fine sand in filtering water after the filter is developed. The study concludes that slow sand filtration is a technically feasible and low-cost technology for reducing the organic load, solids, and turbidity of bio-slurry, but that single stage SSF alone is insufficient to guarantee microbiologically safe effluent. The study recommends the inclusion of a pre-treatment settling stage, an extended filter conditioning and maturation period of at least 30 days, and a downstream disinfection step before treated effluent can be confidently recommended for agricultural reuse or environmental discharge in rural and peri-urban communities in Uganda.
Description
A special project report submitted to the Department of Agricultural and Biosystems Engineering in partial fulfillment of the requirements for the award of Bachelor of Science in Water and Irrigation Engineering of Makerere University.
Keywords
Citation
Tugumisirize, G. (2026, November 17). Evaluating slow sand filtration for bio-slurry post-treatment: A step toward safe non-potable water reuse in rural communities in Uganda [unpublished undergraduate project report], Makerere University, Kampala.