Design and implementation of an Automatic power switch for Grid-solar Hybrid system with the power surge protection.
MetadataShow full item record
In using more than one source of energy, a switching system either manual or automatic is necessary to change from one source of energy to another in case of any disruption in either sources. The current trend is to utilize automatically operated changeover switches, which do not require a person to monitor the available source of energy. However, the current available automatic changeover switches are faced with the switching transients while switching from one source to another, which can be destructive to the load and result into wear of switching contacts. Additionally, a US collaborator is interested in having locally made automatic changeover switches for deployment in health centers in Fort Portal aiming at local capacity development. Therefore, this project sought to locally design and build an automatic changeover switch with reduced switching transients. We simulated the circuit of the changeover switch using proteous simulation tool and Arduino integrated environment, built the prototype of the simulated circuit on the breadboard, and then measured the magnitude of switching transient in the MATLAB Simulink with and without resistor-capacitor (RC) snubber. We finally built a microcontroller based actual automatic changeover switch on the perforated board and tested it for switching using a 2 kW electric kettle. The measured switching transient in MATLAB Simulink without an RC snubber connected across the switch was 23 V for the source of 240 Vrms. This reduced to 10 V when an RC snubber was connected across the switch, which is about 57% reduction in the magnitude of the switching transients. Similarly, the actual changeover switch built successfully switches from one source to another as desired. We recommend voltage sensors to be used together with the power modules capable of changing 240 VAC to 5 VDC directly, and contactors for switching larger loads.